| CPE Plug-N-Play Wiring Harness For CPE Standback: Mazdaspeed 3
The Standback™ engine management system is truly an incredible piece of
hardware. But its success has been limited by the fact that the end-user
has had to cut, splice, and solder wires in order to install it into the
vehicle. Obviously this causes a problem for people as it puts your
vehicle’s warranty at jeopardy. And those who are not technically savvy
may have trouble installing such a complex device. Plug and Play solves all of these
problems.
What is Plug and Play exactly? Plug and Play (or PNP for short) enables a
customer to install and remove the Standback™ engine management system
without any modifications to the vehicle. CPE can do this because they use
the same factory connectors as the stock ECU. So you can literally plug
the Standback™ in and remove it, in just a few minutes, whenever you do
not need it.
There are two important implications here. First, your vehicle’s
warranty is no longer at risk since there are no traces of modification
to the vehicle. Second, you can easily swap the Standback™ in and out of
your car, or even bring it to a friend’s car to try.
The PNP™ option comes with board mounted OEM ECU connectors, cp-e™ wiring
harness, map switch, and bi-color LED. Everything you will need for a
complete installation. The PNP™ board is also encased in urethane to
protect the unit against shock, moisture, and electrical shorts. So you
can mount it just about anywhere in the vehicle.
|
