Magnecor Spark Plug Wires (7mm): Mazda Miata 90-2000
Application: Mazda Miata 90-2000
Part Number: 47168

OVERALL LEAD ASSEMBLY
Outside Diameter of Cable: 7mm
Color: Black
Country of Manufacture: USA

CABLE
Construction Type: Two section: Insulator bonded with tape to high tear strength, high heat resistant outer jacket.
Insulator Material: High dielectric silicone rubber.
Outer Jacket Material: Extreme high tear strength, high temperature resistant silicone rubber.
Heat Resistance: 205o C (400o F) service temperature.
Dielectric Strength: 45,000 volts.

CONDUCTOR
Conductor Size: 1.90 mm in diameter.
Conductor Type: Magnecor Metallic Inductance RFI and EMI Suppressed. No conductive coatings applied.
Core: Ferrimagnetic base over Kevlar and fiberglass substrate.
Windings: 77 turns per cm (200 turns per inch).
Windings Material: Stainless steel.
Resistance: 98.4 ohm per cm, 3K ohm per ft. + 10%.
Capacity: 45,000 volts, 2kVA.

Magnecor produces vastly superior replacements for OE and aftermarket ignition wires using carbon conductors or resistor / connectors at lead ends, all of which reduce spark energy when deterioration develops with usage. Magnecor 7mm ELECTROSPORTS 70 SS IGNITION CABLE, with its updated high-tech wire-wound conductor, will properly suppress both RFI and EMI on all engines without reducing spark current or deteriorating with use. The high tear strength silicone rubber insulating jacket provides better insulation than most 8mm aftermarket ignition leads, and new construction provides better terminal retention than ever before. Any lead set using ELECTROSPORTS 70 SS IGNITION CABLE can be used on both older and newer carburetted engines as well as the most modern fuel injected engines using any electronic engine management system. Suppression is also provided for 2-way radio and computer equipment.